The dimensions of the cable, including the tube, for all K/CB models

  The CB pivot pin sizes and materials

  The Morgan 22 complete system…but applicable to the other models

  The stuffing box details

  Factory recommended maintenance

  Factory centerboard removal instructions and diagrams for M22, M28(?) and M38

  Ray Mummery's version of Dave Doolin's design

  Morgan 25 drawings from Capt. Rick

  Why stainless steel screws corrode?

  > Notes…erratas…and other stuff:

1. Larry Dill reports this: Also, note that my M-34 has a shorter "A" distance than shown in the chart -- closer to the length shown for the bronze board (mine is 22.25"). My boat never had a bronze board -- it is close to the last one built (and by at least one accounts, was the last). M-34 #341, and also: For the record, the complete assy identified as M-22 is probably not an M-22. Principal difference is that the 22 has a Delrin shaft; and I know that the winch is different than that of the M-34. I seem to recall that this information is included in the information compilation (sometimes referred to as the manual) for the M-22, which manual is sold by Warren Pandy at Catalina Yacht. Perhaps your source presumed this was for a M-22. In any event, although not exactly M-22, the information is applicable to the 22 (although it could be the drawing of an M-34 system, as well as many others, I suspect). M-22 #19